General Service InformationGeneral Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury...
Repair procedures Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. 2. Adjust the hood height by turning the hood overslam bumpers (C). 3. After loosening the hood latch (D) mounting bolts, adjust the latch by moving it up or down, or right or left...
Troubleshooting Trouble symptomProbable causeRemedyDisplayed the warning lamp "E"(Driving is only possible with 1/ R gear)Not performed DCT learningPerform the DCT manual learning procedure.Impossible to driving with odd gearClutch actuator (Clutch motor 1 or position sensor 1 failure)Replace the clutch actuator assembly...