| Removal and Installation |
| 1. |
Remove the water temperature control assembly.
(Refer to Colling System - "Water Temperature Control Assembly") |
| 2. |
Remove the water pipe (A).
|
| 3. |
Install in the reverse order of removal. |
Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Replacement or repair of the Steering column - Detection of DTC codes (C1260, C1261) - Replacement of the sensor cluster - Replacement of HECU Calibration procedure Perform wheel alignment and stand the steering wheel in a line within ±5°error...
Configuration State 1. Driving state Sensor transmissions occur every 1 minutes and pressure is measured every 15 seconds. 2. Stationary state Sensor transmissions does not occur and pressure is measured every 60 seconds. 3. Auto learning status When driving after stopping more than 15 minutes , sensor transmissions occur every 33 seconds and pressure is measured every 10...