| Components |

| 1. Turbine housing 2. Turbine inlet 3. Turbine outlet 4. Compressor housing 5. Compressor inlet | 6. Compressor outlet 7. Center housing 8. Actuator 9. Actuator rod |
Intercooler Repair proceduresRemoval and Installation 1. Disconnect the battery negative terminal. 2. Remove the intercooler inlet hoses & pipe (A). Tightening torque Bolt : 19...
Turbo Charger Repair proceduresOn-vehicle Inspection Turbocharger Diagnostic Flow If any problem related with turbocharger, such as lack of engine power, poor acceleration, abnormal engine noise or oil leaks, may occur, check the turbocharger according to the procedure as follows...
Description • Components location : DCT (Dual Clutch Transmission) • Function - The inhibitor switch mounted on the upper of transaxle and connected with shifter lever. - The inhibitor switch has four points of contact and it makes the signals(S1, S2, S3, S4)...
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt...