High Pressure Fuel Pump Repair proceduresRemoval Whenever the high pressure fuel pump, fuel pipe, deliverypipe, or injector is removed immediately after shutting offthe engine, an injury may be caused by the release ofhighly pressurized fuel...
General InformationSpecifications Specifications Joint typeMax. permissible angleOuterInnerOuterInnerBJ#95LSJ#9545°21°BJ#104LSJ#10045°21° Tightening Torques ItemN...
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt...
Removal 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...