| Removal |
| 1. |
Loosen the drain plug and drain the coolant. Open the radiator cap to make rapid draining.
(Refer to Cooling System - "Coolant") |
| 2. |
Disconnect the oil cooler hose (A).
|
| 3. |
Remove the oil filter (A) with the SST (09263-2E000, the oil filter wrench).
|
| 4. |
Loosen the mounting bolt (A), and then remove the oil cooler (B).
|
| Installation |
| 1. |
Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler (C) with fix bolt (B).
|
| 2. |
Install the oil filter (A) with the SST (09263-2E000, the oil filter wrench).
|
| 3. |
Install the oil cooler (A).
|
| 4. |
Fill the radiator with coolant and check for leaks. |
Oil Level Gauge & Pipe Repair proceduresRemoval and Installation 1. Remove the oil lever gauge (A). Tightening torque: 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft) 2. Install in the reverse order of removal...
EPB Release 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Connect the GDS to the data link connector located underneath the dash panel. 3. Select and operate according to the instructions on the GDS screen. (1) Select vehicle name...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor. Specification Evaporator core temperature [°C (°F)]Resistance[K?]Voltage[V]-10 (14)8...