| Replacement |
| 1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
| 2. |
Remove the rear door side curtain assembly.
(Refer to Rear Door - "Rear door side curtain assembly") |
| 3. |
After loosening the mounting screws, then remove the rear door inside handle (A).
|
| 4. |
Install in the reverse order of removal.
|
Rear Door Trim Repair proceduresReplacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Inspection [Motor] 1. Turn ignition switch OFF. 2. Disconnect the EWGA connector. 3. Check that the EWGA is stuck by foreign material. 4. Measure resistance between motor (+) and (-) control terminals of the motor. 5. Check that the resistance is within the specification...
Remove and Installation 1. Remove the cylinder head assembly. (Refet to Cylinder Head Assembli - "Cylinder Head") 2. Remove the water jacket seperator (A). Be careful not to deform or damage it when removing. 3. Install in the reverse order of removal...