| Inspection |
|
| 1. |
Park the vehicle on flat ground and turn off the engine. |
| 2. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
| 3. |
Remove the oil filler plug (A), and check the oil state and oil level.
|
| 4. |
Install the filler plug bolt (A) with new gasket.
|
| 5. |
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
| Replacement |
In principle, the Dual Clutch Transmission (DCT) oil is not changed under normal driving conditions.
However, under harsh driving conditions, it must be changed every 80,000 miles.
Harsh driving conditions are as follows:
|
| 1. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
| 2. |
Remove the drain plug (A) and drain all the oil. Then install the drain plug with a new gasket.
|
| 3. |
Add new oil through the filler plug hole (A) and, fill it just below the plug opening.
|
| 4. |
Install the filler plug bolt (A) with new gasket.
|
| 5. |
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
Transmission Gear Oil General InformationGeneral Information 1. Check & Change intervals Check & ReplenishmentChangeCapacityOil specificationNormal UseSevere Use60000 km / 4 years(40000 miles / 4 years) No service required120000 km(80000 miles)1...
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Circuit Diagram • COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower) • FR signal - The transistor activation signal inside the alternator monitors the voltage generated by the alternator to control the excitation current before it sends the FR signal to the ECM...