| Removal and Installation |
| 1. |
Remove the oil lever gauge (A).
|
| 2. |
Install in the reverse order of removal. |
Oil Pan Repair proceduresRemoval 1. Remove the under covers. 2. Drain engine oil. 3. Using the SST (09215-3C000) and remove the oil pan. • Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow...
Oil Cooler Repair proceduresRemoval 1. Loosen the drain plug and drain the coolant. Open the radiator cap to make rapid draining. (Refer to Cooling System - "Coolant") 2...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...
Inspection [Measuring Resistance] 1. Disconnect the smart cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed). Function switchTerminalResistanceSET -3 - 5550?±5%RES +3 - 5880?±5%CANCEL3 - 5330?±5%CRUISE3 - 51...