| Removal and Installation |
| 1. |
Remove the engine cover. |
| 2. |
Disconnect the battery negative terminal. |
| 3. |
DIsconnect the air duct (A).
|
| 4. |
Remove the air duct and air cleaner assembly.
|
| 5. |
Install in the reverse order of removal. |
| 1. |
Open the service cover (A)
|
| 2. |
Replace the air cleaner element (A) with a new one.
|
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. 4. Check that the resistance is within the specification...
Component Location 1. Heater unit assembly Compoents (1) 1. Mode actuator2. Mode bracket plate3. Mine link plate4. Temperature control actuator [LH]5. Washer6. Face door lever7. Foot & Defrost midole lever8. Servo lever arm [LH]9. Door lever arm [LH]10...