Hyundai Sonata LF: Heater / Heater Unit Components and Components Location

Hyundai Sonata LF 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Heater Unit Components and Components Location

Component Location

1. Heater unit assembly


Compoents (1)

1. Mode actuator
2. Mode bracket plate
3. Mine link plate
4. Temperature control actuator [LH]
5. Washer
6. Face door lever
7. Foot & Defrost midole lever
8. Servo lever arm [LH]
9. Door lever arm [LH]
10. Foot & Defrost door lever [LH]
11. Shower duct [LH]
12. Heater core bracket
13. Rear heater duct seal [LH]
14. Speed nut
15. Adaptor heater case [LH]
16. Rear console duct seal
17. Heater case [LH]
18. Center duct seal
19. Heater core & Seal assembly
20. Defroster door assembly
21. Vent door assembly
22. Floor door assembly
23. Temperature door assembly
24. Heater unit pad
25. Separator
26. Adaptor heater case [RH]
27. Heater case [RH]
28. Rear heater duct seal [RH]
29. Door lever arm [RH]
30. Servo lever arm [RH]
31. Aspirator assembly
32. Drain hose
33. Heater lower cover
34. Evaporator sub assembly
35. Temperature control actuator [RH]
36. Evaporator thermistor sub assembly
37. Shower duct [RH]

    Heater

    ..

    Heater Unit Repair procedures

    Replacement     When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: General Information


    General Information The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the driver, passenger, side airbag and belt pretensioner in certain frontal or side collisions...

    Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Repair procedures


    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org