Hyundai Sonata LF: General Information / Special Service Tools

Hyundai Sonata LF 2014-2019 Service Manual / Engine Mechanical System / General Information / Special Service Tools

Special Service Tools
Tool (Number and name)
Illustration
Use
Crankshaft front oil seal installer
(09455-21200)

Installation of the front oil seal
Valve stem oil seal installer
(09222-2B100)

Installation of the valve stem oil seal
Valve spring compressor and holder
A : (09222-3K000)
B : (09222-3K100)

Removal and installation of the intake or exhaust valve
Crankshaft rear oil seal installer
A : (09231-H1100)
B : (09231-2B200)

Installation of the crankshaft rear oil seal
Ring gear stoppper
(09231-2B100) (A)
(09231-3N100) (B)

Removal and installation of crankshaft pulley bolt.
Ring gear stopper
(09231-3D100) (A)
(09231-2W100) (B)

Removal and installation of crankshaft pulley bolt.
Oil pan remover
(09215-3C000)

Removal of oil pan
Torque angle adapter
(09221-4A000)

Installation of bolts & nuts needing an angular method
Oil filter wrench
(09263-2E000)

Remove and installation of oil filter

    Troubleshooting

    Troubleshooting SymptomSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Loose or improperly installed engine flywheel.Repair or replace the flywheel as required...

    Engine And Transmission Assembly

    ..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Steering Angle Sensor Repair procedures


    Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Replacement or repair of the Steering column - Detection of DTC codes (C1260, C1261) - Replacement of the sensor cluster - Replacement of HECU Calibration procedure Perform wheel alignment and stand the steering wheel in a line within ±5°error...

    Hyundai Sonata LF 2014-2019 Service Manual: Knee Airbag (KAB) Module Repair procedures


    Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the mounting nuts (A). 4. Disconnect the knee airbag connector (B)...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org