Hyundai Sonata LF: Cooling System / Water Temperature Control Assembly Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures

Removal and Installation

1.	Loosen the drain plug, and drain the engine coolant. Remove the radiator cap to drain with speed.

2.	Disconnect the battery negative terminal.

3.	Remove the air cleaner assembly. (Refer to Intake and exhaust system - "Air Cleaner")

4.	Disconnect the water temperature sensor connector (A).

5.	Disconnect the radiator upper hose (B).

6.	Remove the heater hose (C).

7.	Disconnect the water hose (D).

Remove the water temperature control assembly (B).

Tightening torque :

9.8 ~ 11.7N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)

Install in the reverse order of removal.

Clean the surface of the water temperature control assembly before installing.

Water Temperature Control Assembly Components and Components Location

C..

Water Pipe Components and Components Location

C..

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Rail Pressure Sensor (RPS) Description and Operation

Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal...

Hyundai Sonata LF 2014-2019 Service Manual: Rear Door Outside Handle Components and Components Location