| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the driver door trim.
(Refer to Body - "Front Door Trim") |
| 3. |
Remove the memory power seat switch connector (A).
|
| 4. |
Remove the memory power seat switch (A) after loosening the mounting screws.
|
| Installation |
| 1. |
Install the memory power seat control switch (IMS). |
| 2. |
Install the door trim. |
| 3. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
Remove the memory power seat connector
|
| 2. |
When each switch is pressed, check the electricity flow
between memory power seat switch connector and grounding, and if the
electricity does not match the specification, replace the switch.
|
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Side Impact Sensor (SIS) signal. Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1...