| Remove and Installation |
| 1. |
Remove the cylinder head assembly.
(Refet to Cylinder Head Assembli - "Cylinder Head") |
| 2. |
Remove the water jacket seperator (A).
|
| 3. |
Install in the reverse order of removal. |
Removal Engine removal is required for this procedure. (Refer to Engine and transaxle assembly removal in this group) 1. MT : Remove the flywheel. (Refet to Cylinder Block - "Flywheel") 2. AT : Remove the drive plate. (Refet to Cylinder Block - "Drive Plate") 3...
Replacement 1. Loosen the rear door checker (B) mounting bolt. 2. Detach the clips, then remove the rear door side weatherstrip (A). Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft) 3. Install in the reverse order of removal...