EPB Switch Repair proceduresRemoval 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console assembly. (Refer to Body - “Floor console assembly") 3...
Inspection 1. Connect a GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable...
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection...