| Removal |
| 1. |
Turn ignition OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the floor console assembly.
(Refer to Body - “Floor console assembly") |
| 3. |
Remove the EPB switch after loosening the screws.
|
| 4. |
Install in the reverse order of removal. |
Electric Parking Brake (EPB) Repair proceduresEPB Release 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Connect the GDS to the data link connector located underneath the dash panel...
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection...
Replacement • When removing and installing the hood lift, an assistant is necessary. • When removing the hood lift, first remove the lower portion and then upper portion. 1. Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lift (B), and then remove the lift from the bracket...