Hyundai Sonata LF: ESP(Electronic Stability Program) System / Front Wheel Speed Sensor Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Brake System / ESP(Electronic Stability Program) System / Front Wheel Speed Sensor Repair procedures

Removal
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the wheel cap(A).

   
Be careful not to damage to the wheel cap(A) when removing the it.
3.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
4.
Remove the front wheel speed sensor mounting bolt (A).
Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

5.
Remove the front wheel speed sensor cable mounting bolt (A).
Tightening torque:
Shock absorber : 8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Body : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)

6.
Disconnect the front wheel speed sensor connector, then remove the front wheel speed sensor.

7.
Installation is the reverse of removal.
Inspection
1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
   
In order to protect the wheel speed sensor, when measuring output voltage, a 100 ? resister must be used as shown.

2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V ~ 0.84V
V_high : 1.18V ~ 1.68V
Frequency range : 1 ~ 2,500Hz

    Front Wheel Speed Sensor Components and Components Location

    C..

    Rear Wheel Speed Sensor Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Oil Pump Repair procedures


    Removal and Installation 1. Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover") 2. Remove the pump cover (A). Tightening torque : 8.8 ~ 13.7N.m (0.9 ~ 1.4kgf.m, 6.5 ~ 10.1 lb-ft) 3. Remove the inner rotor (B) and outer rotor (C)...

    Hyundai Sonata LF 2014-2019 Service Manual: Steering Angle Sensor Repair procedures


    Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Replacement or repair of the Steering column - Detection of DTC codes (C1260, C1261) - Replacement of the sensor cluster - Replacement of HECU Calibration procedure Perform wheel alignment and stand the steering wheel in a line within ±5°error...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org