| Repair procedures |
| 1. |
Remove the reservoir cap and fill the brake reservoir with brake fluid.
|
| 2. |
Connect a clear plastic tube to the wheel cylinder bleeder
plug and insert the other end of the tube into a half filled clear
plastic bottle. |
| 3. |
Connect the GDS to the data link connector located underneath the dash panel. |
| 4. |
Select and operate according to the instructions on the GDS screen.
|
| 5. |
Have someone slowly pump the brake pedal several times, and then apply pressure. |
| 6. |
Loosen the right-rear brake bleed screw (A) to allow air to escape from the system. Then tighten the bleed screw securely.
[Front]
[Rear]
[General]
[EPB]
|
| 7. |
Repeat the procedure for wheel in the sequence shown below until air bubbles no longer appear in the fluid.
|
| 8. |
Refill the master cylinder reservoir to MAX(upper) level line. |
TroubleshootingFailure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited...
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation. 3. Replace the blower motor if it is proved that there is a problem with it...
Components Rear sear back assembly 1. Rear seat back cover2. Rear seat back pad3. Rear seat headrest guide4. Rear seat headrest5. Rear seat back webbing guide6. Rear back armrest 7. Rear seat back panel assembly Rear seat cushion assembly 1...