| Removal |
| 1. |
Loosen the drain plug and drain the coolant. Open the radiator cap to make rapid draining.
(Refer to Cooling System - "Coolant") |
| 2. |
Disconnect the oil cooler hose (A).
|
| 3. |
Remove the oil filter (A) with the SST (09263-2E000, the oil filter wrench).
|
| 4. |
Loosen the mounting bolt (A), and then remove the oil cooler (B).
|
| Installation |
| 1. |
Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler (C) with fix bolt (B).
|
| 2. |
Install the oil filter (A) with the SST (09263-2E000, the oil filter wrench).
|
| 3. |
Install the oil cooler (A).
|
| 4. |
Fill the radiator with coolant and check for leaks. |
Oil Level Gauge & Pipe Repair proceduresRemoval and Installation 1. Remove the oil lever gauge (A). Tightening torque: 9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft) 2. Install in the reverse order of removal...
Components and Components Location Component Location 1. Panorama sunroof2. Panorama sunroof switch3. Panorama sunroof motor & controller4. Roller blind motor & slave controller Schematic Diagrams Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass status signal / tool(parameter)Blind signal3BCM EnableBCM Enable-4Tilt up switchTilt up switch-5GND 2--6BATT 1BATT 1BATT 27---8Vehicle speed signalVehicle speed signalVehicle speed signal9Glass open switch Glass open switchBlind open switch10Glass close switch Glass close switchBlind close switch11BATT 212Blind open switch 13Blind close switch 14Blind signal Panorama Sunroof Switch Components and Components Location Components Panorama Sunroof Switch Repair procedures Inspection 1...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Rmove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector...