Hyundai Sonata LF: Blind Spot Detection system / Blind Spot Detection Switch Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / Blind Spot Detection system / Blind Spot Detection Switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Rmove the blind spot detection (BSD) switch (A) after disengaging the mounting clip.

Installation
1.
Install the crash pad side switch assembly after connecting the connector.
2.
Install the crash pad lower panel.
Inspection
1.
Disconnect the BSD switch connector (A).

2.
Operate the BSD switch, then check for continuity between terminals of BSD switch connector.

    Blind Spot Detection Switch Components and Components Location

    C..

    Blind Spot Detection Indicator Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Stop Signal Electronic Module Repair procedures


    Inspection 1. Fuse inspection Mount the test fuse to the switch fuse and relay fuse part to confirm a normal joint fit. 2. Inspection of connector by each part Check to see whether or not each connector has been damaged, or terminal surge, or incomplete connection has taken place [Engine room junction box] [Stop signal electronic module] [ABS/VDC control module] 3...

    Hyundai Sonata LF 2014-2019 Service Manual: Front Disc Brake Repair procedures


    Removal 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap(A).     Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...

    Categories

    read more

     
    Copyright В© 2026 www.hsonatalf.org