Hyundai Sonata LF: Engine Control System / Rail Pressure Sensor (RPS) Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation

Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

    Heated Oxygen Sensor (HO2S) Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 2 and 5 [B1/S1]...

    Rail Pressure Sensor (RPS) Specifications

    S..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Temperature Control Actuator Description and Operation


    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch...

    Hyundai Sonata LF 2014-2019 Service Manual: Engine And Transmission Assembly Repair procedures


    Removal 1. Remove the engine cover. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Remove the air duct and air cleaner assembly. (Refer to Intake and Exhaust System - "Air Cleaner") 4. Remove the engine room under cover...

    Categories

    read more

     
    Copyright В© 2026 www.hsonatalf.org