Hyundai Sonata LF: Heater / Temperature Control Actuator Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Temperature Control Actuator Description and Operation

Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.

    Temperature Control Actuator Components and Components Location

    C..

    Temperature Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Fuel Pressure Sensor (FPS) Schematic Diagrams


    Circuit Diagram Fail-Safe Mode Item Fail-Safe Output Voltage (V) 12     If the fuel pressure sensor malfunctions, it enters fail safe mode. This means that the fuel pressure rises to match the increasing value of the current level and the pressure in the low pressure fuel line remains static despite the rising fuel pressure...

    Hyundai Sonata LF 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures


    Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org