Hyundai Sonata LF: Engine Control System / Heated Oxygen Sensor (HO2S) Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Description and Operation

Description

Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio.

The sensor must be hot in order to operate normally. To keep it hot, the sensor has a heater which is controlled by the ECM via a duty cycle signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

Knock Sensor (KS) Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group)...

Heated Oxygen Sensor (HO2S) Specifications

Specification HO2S [Bank 1/Sensor 1] (Linear type) ItemSpecificationHeater Resistance (?)2.4 ~ 4.0 [20°C(68°F)] ItemSpecificationHeater Resistance (?)Approx...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Compressor Repair procedures

Removal Precautions for using the plastic pulley • Take care not to give physical impact to the plastic pulley. If exposed to the impact of dropping and collision, the pulley should not be used although not damaged. • Be careful not to place the pulley to downwards of the floor or table...

Hyundai Sonata LF 2014-2019 Service Manual: AVN Remote Controller (Sonata Sports) Schematic Diagrams