Hyundai Sonata LF: Engine Control System / Knock Sensor (KS) Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS) Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).

3.	Disconnect the injector connector (A).

4.	Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

Install in the reverse order of removal.

Knock sensor installation bolt:

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Knock Sensor (KS) Schematic Diagrams

C..

Heated Oxygen Sensor (HO2S) Description and Operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: General Information

General Information The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the driver, passenger, side airbag and belt pretensioner in certain frontal or side collisions...

Hyundai Sonata LF 2014-2019 Service Manual: Oil Pump Repair procedures