| Removal |
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
| 2. |
Disconnect the fuel sender connector (A).
|
| 3. |
Remove the fuel sender (A) after releasing the fix hook.
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Pump Motor Repair proceduresRemoval 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A), and the fuel sender connector (B)...
Fuel Pressure Regulator Repair proceduresRemoval 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Remove the fuel pressure regulator fixing clip (A). 3. Remove the fuel pressure regulator (B) from the fuel filter...
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal...
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable...