Hyundai Sonata LF: Rear Suspension System / Rear Shock Absorber Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Suspension System / Rear Suspension System / Rear Shock Absorber Repair procedures

Replacement
1.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the wheel cap (A).

   
Be careful not to damage to the wheel cap (A) when removing the it.
3.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

   
Be careful not to damage to the hub bolts when removing the front wheel and tire (A).
4.
Loosen the mounting bolt and nut. And then separate the shock absorber from the lower arm.
Tightening torque :
137.3 ~ 156.9 N.m (14.0 ~ 16.0 kgf.m, 101.3 ~ 115.7 lb-ft)

   
Set up the transmission jack under the lower arm in order to remove the shock absorber in no-load condition .
5.
Loosen the shock absorber mounting bolts (A).
Tightening torque :
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

6.
Installation is the reverse of removal.
Inspection
1.
Check the rubber parts for wear and deterioration.
2.
Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.
Disposal
(1)
Fully extend the piston rod.
(2)
Drill a hole on the (A) section to remove gas from the cylinder.

   
The gas coming out is harmless but be careful of chips that may tly when driling.

    Rear Shock Absorber Components and Components Location

    C..

    Rear Upper Arm Repair procedures

    Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Components and Components Location


    Components 1. Cylinder block2. Ladder frame3. Crankshaft4. Crankshaft upper bearing5. Crankshaft lower bearing6. Thrust bearing7. Main bearing cap8. External damper flywheel9. Crankshaft sproket10. Crankshaft pulley11. Water jacket insert 1...

    Hyundai Sonata LF 2014-2019 Service Manual: Fuel Pump Repair procedures


    Inspection [Fuel sender] 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump assembly. 3. Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level...

    Categories

    read more

     
    Copyright В© 2026 www.hsonatalf.org