| Removal |
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
| 2. |
Remove the fuel pressure regulator fixing clip (A). |
| 3. |
Remove the fuel pressure regulator (B) from the fuel filter.
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Sender Repair proceduresRemoval 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the fuel sender connector (A). 3. Remove the fuel sender (A) after releasing the fix hook...
Fuel Pump Control Module (FPCM) Description and OperationDescription The fuel pump control module (FPCM) is installed on the right side of the fuel tank on the fuel pump top plate and controls the DC motor mounted inside the low pressure fuel pump...
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection...
Fuse Inspection 1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct? 3. Are there any blown fuses? If a fuse is to be replaced, be sure to use a new fuse of the same capacity...