| Description |

| Operation |

| 1. |
The ECM provides target fuel pressure information to the FPCM via CAN network. |
| 2. |
The FPS provides the FPCM with actual pressure information of
the low pressure fuel line between the low and high pressure fuel
pumps, and the FPCM forwards the information to the ECM.Also, the FPCM
diagnoses faults in the FPCM, fuel pump motor and FPS and then provides
the diagnosis information to the ECM. |
| 3. |
The FPCM compares the actual fuel pressure information
measured by the FPS with the target fuel pressure information provided
by the ECM and controls the voltage that is provided to the low pressure
fuel pump motor.The FPCM keeps regulating fuel flow rate by controlling
the low pressure fuel pump, depending on engine speed (rpm) and vehicle
loads. |
Fuel Pressure Regulator Repair proceduresRemoval 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Remove the fuel pressure regulator fixing clip (A). 3. Remove the fuel pressure regulator (B) from the fuel filter...
Fuel Pump Control Module (FPCM) SpecificationsSpecification ItemsSpecificationApplied Voltate (V)6~18Current Consumption (A)Max. 15Fuel Pressure StartMax. 600 KPa (Max. 6.1 kgf/cm?, Max. 87...
Removal and Installation Front Muffler 1. Disconnect the battery negative terminal. 2. Disconnect the rear oxygen sensor connector (A). 3. Remove the front muffler (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft) 4...
Component Location 1. Blower unit assembly Components 1. Intake actuator2. Intake case [LH]3. Intake door assembly4. Air filter5. Filter cover assembly6. Intake inlet seal 7. Intake case [RH]8. Intake outlet seal 9. Blower upper cover10. Blower unit pad11...