| Circuit Diagram |

CVVT Oil Control Valve (OCV) Repair proceduresInspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4...
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the mounting cap (A). 4. Remove the installation bolt (A), and then remove the accelerator pedal module...
Inspection 1. Fuse inspection Mount the test fuse to the switch fuse and relay fuse part to confirm a normal joint fit. 2. Inspection of connector by each part Check to see whether or not each connector has been damaged, or terminal surge, or incomplete connection has taken place [Engine room junction box] [Stop signal electronic module] [ABS/VDC control module] 3...