Hyundai Sonata LF: Brake System / Stop Signal Electronic Module Specifications

Hyundai Sonata LF 2014-2019 Service Manual / Brake System / Brake System / Stop Signal Electronic Module Specifications

Specifications
Category
Data
Operation temperature range (°C)
-40 ~ 85
Preserving temperature range (°C)
-40 ~ 105
Operating voltage (V)
5.8 ~ 16
Rated current (A)
15

    Stop Signal Electronic Module Components and Components Location

    C..

    Stop Signal Electronic Module Schematic Diagrams

    S..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Brake Booster Repair procedures


    Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when depressed succeeding times, the booster is operating properly, if the pedal height remains unchanged, the booster is inoperative...

    Hyundai Sonata LF 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS) Repair procedures


    Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform� Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the crankshaft position sensor connector (A) and remove the sensor (B) after removing the installation bolt...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org