| Components |
| Driver Power Window Switch |


| Assist Power Window Switch |


| Rear Power Window Switch |

Power Window Motor Repair proceduresInspection • Wrap the protective tape on the tool to disassemble with the screwdriver or remover. • Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 2 and 5 [B1/S1]. 4. Measure resistance between the HO2S terminals 3 and 4 [B1/S2]. 5. Check that the resistance is within the specification...
Removal When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. [In the case of installing used ECM] 1. Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group) 2...