| Inspection |
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
| 3. |
Disconnect the motor connector from the motor.
|
| 4. |
Connect the terminal No.1 and No.2 to battery voltage (12V)
and check that the motor operates smoothly when connecting the terminals
below.
[Safety Window Motor]
|
| 5. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor.
[Standard Window Motor]
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim") |
| 3. |
Disconnect the motor connector from the motor.
|
| 4. |
Connect the motor terminals No.1 and No.2 directly to battery voltage (12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Window Motor]
|
Removal and Installation Front Muffler 1. Disconnect the battery negative terminal. 2. Disconnect the rear oxygen sensor connector (A). 3. Remove the front muffler (A). Tightening torque: 39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft) 4...
Components and Components Location Component Location 1. Fender assembly Repair procedures Replacement • Be careful not to damage the fender and body. • When removing the clips, use a clip remover...