| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the trunk lid panel.
(Refer to Body - "Trunk Lid Trim") |
| 3. |
Remove the license lamp after disengaging the license lamp mounting clip (A).
|
| 4. |
Remove the license lamp assembly after disconnect the license connector (A).
|
| Installation |
| 1. |
Install the license lamp assembly. |
| 2. |
Install the trunk lid panel. |
| 3. |
Connect the negative (-) battery terminal. |
Front Fog Lamps Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3. Disconnect the front fog lamp connector (A)...
High Mounted Stop Lamp Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the rear package tray trim. (Refer to Body - "Rear Package Tray Trim") 3...
Removal 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap(A). Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calculates the intake air quantity and engine speed...