| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front bumper.
(Refer to Body - "Front Bumper Cover") |
| 3. |
Disconnect the front fog lamp connector (A). |
| 4. |
Remove the front fog lamp assembly (A) after loosening the mounting nut.
|
| Installation |
| 1. |
Install the front fog lamp assembly. |
| 2. |
Connect the front fog lamp connector. |
| 3. |
Install the front bumper. |
| 4. |
Connect the negative (-) battery terminal. |
Rheostat Repair proceduresInspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3...
License Lamps Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid panel. (Refer to Body - "Trunk Lid Trim") 3. Remove the license lamp after disengaging the license lamp mounting clip (A)...
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer to “Specification” ETC Motor 1...
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...