| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the trunk lid panel.
(Refer to Body - "Trunk Lid Trim") |
| 3. |
Remove the license lamp after disengaging the license lamp mounting clip (A).
|
| 4. |
Remove the license lamp assembly after disconnect the license connector (A).
|
| Installation |
| 1. |
Install the license lamp assembly. |
| 2. |
Install the trunk lid panel. |
| 3. |
Connect the negative (-) battery terminal. |
Front Fog Lamps Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3. Disconnect the front fog lamp connector (A)...
High Mounted Stop Lamp Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the rear package tray trim. (Refer to Body - "Rear Package Tray Trim") 3...
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH). Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location...
Troubleshooting SymptomSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Loose or improperly installed engine flywheel.Repair or replace the flywheel as required.Worn piston rings.(Oil consumption may or may not cause the engine to misfire...