Hyundai Sonata LF: Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Intake Air Temperature Sensor (IATS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification�

    Intake Air Temperature Sensor (IATS) Schematic Diagrams

    C..

    Ambient Temperature Sensor (ATS) Description and Operation

    Description Ambient Temperature Sensor (ATS) is installed on the front-end module and senses the ambient temperature. ECM receives not only the intake air temperatue but also the ambient air temperature informations at the same time to control the intake air quantity precisely provided through the turbo charger...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Compressor Description and Operation


    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas...

    Hyundai Sonata LF 2014-2019 Service Manual: Driver Airbag (DAB) Module and Clock Spring Repair procedures


    Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module from the steering wheel after pressing the snap fit pin stopper. 3. Remove the wiring fixing clip (C) and disconnect the horn connector (A)...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org