| Specification |
| Item | Specification |
| Type | Hall effect sensor |
| Operation condition (°C)°F | (-40 ~ 150)-40 ~ 302 |
| Output signal (mA) | High: 11.8 ~ 16.8 |
| Low: 5.9 ~ 8.4 |
Input shaft speed sensor 2 Description and OperationDescription • Components location : DCT (Dual Clutch Transmission) • Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...
Removal [Ventilation Blower] 1. Disconnect the negative (-) battery terminal. 2. Remove the front seat. (Refer to Body - "Front Seat Assembly") 3. Remove the under cover assembly. (Refer to Body - "Front Seat Cushion Cover") 4. Remove the blower fan (A) after removing the fixed clip (B) and screws...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System� in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...