Hyundai Sonata LF: Dual Clutch Transmission Control System / Input shaft speed sensor 2 Description and Operation
| Description |
| • |
Components location : DCT (Dual Clutch Transmission)
|
| • |
Function
The input shaft speed sensor is important in that it detects
the input shaft RPM and sends this information to the Transmission
Control Module (TCM).
It provides important input information for electric control.
The information is needed in all operations, including
feedback control, gear shift control and failure detection of other
sensors. |
Input shaft speed sensor 2 Specifications
Specification ItemSpecificationTypeHall effect sensorOperation condition (°C)°F(-40 ~ 150)-40 ~ 302Output signal (mA)High: 11.8 ~ 16.8Low: 5.9 ~ 8...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Rmove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector...
Hyundai Sonata LF 2014-2019 Service Manual: Water pump Troubleshooting
Troubleshooting SymptomsPossible CausesRemedyCoolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If coolant still leaks, replace a water pump. • If leakage stops, reuse the water pump (Do not replace the pump with a new one)...
Categories
- Manuals Home
- Hyundai Sonata Owners Manual
- Hyundai Sonata Service Manual
- Body Electrical System
- Timing System
- Brake System
- New on site
- Most important about car
