| Specification |
| Item | Specification |
| Type | Hall effect sensor |
| Operation condition (°C)°F | (-40 ~ 150)-40 ~ 302 |
| Output signal (mA) | High: 11.8 ~ 16.8 |
| Low: 5.9 ~ 8.4 |
Input shaft speed sensor 2 Description and OperationDescription • Components location : DCT (Dual Clutch Transmission) • Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...
Removal 1. Disconnect the negative (-) battery terminal. 2. If it is necessary to remove multifunction switch assembly, remove the steering wheel. (Steering System - "Steering Wheel") 3. Remove the steering column upper shrouds (A). (Refer to Body - "Steering Column Shroud Panel") 4...
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when depressed succeeding times, the booster is operating properly, if the pedal height remains unchanged, the booster is inoperative...