Hyundai Sonata LF: Dual Clutch Transmission Control System / Input shaft speed sensor 2 Schematic Diagrams

Hyundai Sonata LF 2014-2019 Service Manual / DCT (Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Input shaft speed sensor 2 Schematic Diagrams

Circuit Diagram

    Input shaft speed sensor 2 Description and Operation

    Description • Components location : DCT (Dual Clutch Transmission) • Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...

    Input shaft speed sensor 2 Repair procedures

    Removal 1. Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner") 2. Remove the battery and tray. (Refer to Engine Electrical System - "Battery") 3...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: TPMS Sensor Description and Operation


    Configuration State 1. Driving state Sensor transmissions occur every 1 minutes and pressure is measured every 15 seconds. 2. Stationary state Sensor transmissions does not occur and pressure is measured every 60 seconds. 3. Auto learning status When driving after stopping more than 15 minutes , sensor transmissions occur every 33 seconds and pressure is measured every 10...

    Hyundai Sonata LF 2014-2019 Service Manual: Curtain Airbag (CAB) Module Description and Operation


    Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by using side impact sensor (SIS) signal.     Never attempt to measure the circuit resistance of the airbag module even if you are using the specified tester...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org