Hyundai Sonata LF: Dual Clutch Transmission Control System / Input shaft speed sensor 2 Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / DCT (Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Input shaft speed sensor 2 Repair procedures

Removal

1.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner")

2.	Remove the battery and tray. (Refer to Engine Electrical System - "Battery")

3.	Remove the clutch actuator. (Refer to Dual Clutch Control System - "Clutch Actuator")

4.	Disconnect the input shaft speed sensor (A).

5.	Remove the input shaft speed sensor after removing the bolt (A-2ea).

Installation

Install in the reverse order of removal.

•	Before installing the input speed sensor,check the assembled state of the O-rings (A) and should apply gear oil to the surface of O- rings.

Input shaft speed sensor 2 Schematic Diagrams

C..

Inhibitor Switch Components and Components Location

C..

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Blind Spot Detection Unit Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor...

Hyundai Sonata LF 2014-2019 Service Manual: Seat Heater Switch Schematic Diagrams