Hyundai Sonata LF: Dual Clutch Transmission Control System / Input shaft speed sensor 1 Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / DCT (Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Input shaft speed sensor 1 Repair procedures

Removal

1.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechnical System - "Air cleaner")

2.	Remove the TCM. (Refer to Dual Clutch Transmission Control System - "TCM")

3.	Remove the battery and tray. (Refer to Engine Electrical System - "Battery")

4.	Remove the clutch actuator. (Refer to Dual Clutch Transmission Control System - "Clutch Actuator")

5.	Disconnect the input shaft speed sensor (A).

6.	Remove the input shaft speed sensor after removing the bolt (A-2ea).

Installation

Install in the reverse order of removal.

•	Before installing the input speed sensor,check the assembled state of the O-rings (A) and should apply gear oil to the surface of O- rings.

Input shaft speed sensor 1 Schematic Diagrams

C..

Input shaft speed sensor 2 Components and Components Location

C..

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Rear Seat Assembly Repair procedures

Replacement [Rear seat cushion assembly] 1. Remove the rear seat cushion assembly (A). ?Rear seat cushion separation method 1. Remove the rear seat cushion by pulling upward. 2. Remove the rear seat cushion by pulling upwards while pushing rearward...

Hyundai Sonata LF 2014-2019 Service Manual: Smart Key Repair procedures