Hyundai Sonata LF: Seat Electrical / Seat Heater Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Repair procedures

Inspection
Front Seat Heater
1.
Check for continuity and measure the resistance between terminals No 3 and No 6.


Standard value
Driver / Assists (cushion + back) : 1.58±10%

2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value
1st : cushion : 36±2°C, back : 40±2°C
2st : cushion : 39±2°C, back : 45±2°C
3st : cushion : 42±2°C, back : 50±2°C

Front Seat Heater (Air Ventilation)
1.
Check for continuity and measure the resistance between terminals.


Standard value
Cushion (Teminal : 4-6) : 2.94?±10%
Back (Teminal : 5-6) : 2.71?±10%

2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value
1st : cushion : 36±2°C, back : 40±2°C
2st : cushion : 39±2°C, back : 45±2°C
3st : cushion : 42±2°C, back : 50±2°C

Rear Seat Heater
1.
Check for continuity and measure the resistance between terminals No 1 and No 4.


Standard value
Rear seat : 2.82?±10%

2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

Standard value
High (Cushion) : 38±2°C
Low (Cushion) : 42±2°C

    Seat Heater Schematic Diagrams

    C..

    Seat Heater Switch Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Canister Repair procedures


    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - " Fuel Tank") 3. Disconnect the vent hose (A). 4. Disconnect the vapor tube quick-connector (B,C)...

    Hyundai Sonata LF 2014-2019 Service Manual: Purge Control Solenoid Valve (PCSV) Description and Operation


    Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in the canister is transferred to the intake manifold...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org