| Replacement |
Put on gloves to protect your hands. |
|
| 1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
| 2. |
After loosening the mounting screws, then remove the rear door side curtain assembly (A).
|
| 3. |
Install in the reverse order of removal. |
Rear Door Latch Repair proceduresReplacement 1. Remove the rear door module. (Refer to Rear Door - "Rear Door Module") 2. Disconnect the rear door latch connector (A). 3. Remove the rear door inside handle cage (A)...
Body Side MoldingRoof Side Molding Repair procedures Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Circuit Diagram • COM signal - When controlling the voltage generated, the ECM sends the target voltage data to the alternator via a PWM signal.(High voltage: 4V or higher, low voltage: 2V or lower) • FR signal - The transistor activation signal inside the alternator monitors the voltage generated by the alternator to control the excitation current before it sends the FR signal to the ECM...
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return...