| Replacement |
| 1. |
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module") |
| 2. |
Disconnect the rear door latch connector (A).
|
| 3. |
Remove the rear door inside handle cage (A).
|
| 4. |
Remove the rear door inside handle cable (A) by pushing it rearward.
|
| 5. |
Remove the rear door outside handle base (A) by pushing in the lock pins located in the back.
|
| 6. |
Remove the rear door outside handle cable (A).
|
| 7. |
Install in the reverse order of removal.
|
Rear Door Curtain Assembly Repair proceduresReplacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
S..
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel...