| Inspection |
| 1. |
Troubleshooting for Speaker
| ||||||||||||||||||||||||||||||||||||||||||
| Removal |
| 1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
| 2. |
Remove the front door speaker (A) after disconnect the connector and loosening the screws.
|
| 1. |
Remove the Rear door trim.
(Refer to Body - "Rear Door Trim") |
| 2. |
Remove the rear door speaker (A) after disconnect the connector and loosening the screws.
|
Take care not to scratch the crash pad and related parts. |
| 1. |
Using a screwdriver or remover, remove the crash pad center speaker grille (A).
|
| 2. |
Remove the center speaker (A) after disconnect the connector and loosening the screws.
|
| 1. |
Remove the rear seat.
(Refer to Body - "Rear Seat") |
| 2. |
Remove the package tray trim.
(Refer to Body - "Rear Package Tray Trim") |
| 3. |
Remove the sub woofer speaker (A) after disconnect the connector and loosening the bolts.
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the left/right crash pad side speaker grille (A).
|
| 3. |
Remove the midrange speaker (A) after disconnect the connector and loosening the screws.
|
| Installation |
| 1. |
Install the front door speaker. |
| 2. |
Install the front door trim. |
| 1. |
Install the rear door speaker. |
| 2. |
Install the rear door trim. |
| 1. |
Install the center speaker. |
| 2. |
Install the center speaker grille. |
| 1. |
Install the midrange speaker |
| 2. |
Install the crash pad side speaker grille. |
| 3. |
Connect the negative (-) battery terminal. |
| 1. |
Install the subwoofer speaker. |
| 2. |
Install the rear package tray and rear seat. |
Make sure the speaker connectors are plugged in properly. |
AVN Antenna Repair proceduresInspection Glass Antenna Test 1. Wrap aluminum foil (A) around the tip of the tester probe (B) as shown. 2. Touch one tester probe to the glass antenna terminal (A) and move the other tester probe along the antenna wires to check that continuity exists...
Specifications DescriptionSpecificationsLimitGeneralTypeIn-line, DOHC?Number of cylinders4?Bore77mm (3.0315in)?Stroke85.44mm (3.3638in)?Total displacement1,591 cc (97.09 cu.in)?Compression ratio9.5 : 1?Firing order1-3-4-2?Valve timingIntake valveOpensATDC 8°/BTDC 42°?ClosesABDC 69°/ABDC 19°?Exhaust valveOpensBBDC 40°/BBDC 0°?ClosesATDC 3°/ATDC 43°?Cylinder headFlatness of gasket surfaceLess than 0...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper. (Refer to Body - "Front Bumper Cover") 3. Disconnect the front fog lamp connector (A). 4. Remove the front fog lamp assembly (A) after loosening the mounting nut...