| Inspection |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the IATS connector. |
| 3. |
Measure resistance between the IATS terminals 3 and 4. |
| 4. |
Check that the resistance is within the specification.
|
Ambient Temperature Sensor (ATS) Description and OperationDescription Ambient Temperature Sensor (ATS) is installed on the front-end module and senses the ambient temperature. ECM receives not only the intake air temperatue but also the ambient air temperature informations at the same time to control the intake air quantity precisely provided through the turbo charger...
Replacement Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Components and Components Location Component Location 1. Panorama sunroof2. Panorama sunroof switch3. Panorama sunroof motor & controller4. Roller blind motor & slave controller Schematic Diagrams Circuit Diagram NoSunroof wiringconnector(Vehicle side)Sunroof wiringconnector(Motor)Panorama glass motor(Master)Blind motor(Slave)1GND 1 GND 1GND 22Glass statussignal / tool(parameter)Glass status signal / tool(parameter)Blind signal3BCM EnableBCM Enable-4Tilt up switchTilt up switch-5GND 2--6BATT 1BATT 1BATT 27---8Vehicle speed signalVehicle speed signalVehicle speed signal9Glass open switch Glass open switchBlind open switch10Glass close switch Glass close switchBlind close switch11BATT 212Blind open switch 13Blind close switch 14Blind signal Panorama Sunroof Switch Components and Components Location Components Panorama Sunroof Switch Repair procedures Inspection 1...