Hyundai Sonata LF: Body (Interior and Exterior) / Trunk Trim. Repair procedures
Repair procedures
| • |
Put on gloves to protect your hands. |
|
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage. |
| • |
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. |
| • |
Take care not to bend or scratch the trim and panels. |
|
| 1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
| 2. |
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
| 3. |
Remove the rear package tray trim.
(Refer to Interior Trim - "Package Tray Trim") |
| 4. |
Remove the luggage cover board (A). |
| 5. |
Remove the rear transverse trim (B). |
| 6. |
Remove the luggage partition side trim (C). |
| 7. |
After loosening the mounting screws, then remove the luggage side trim (D). |
| 8. |
Install in the reverse order of removal.
| • |
Replace any damage clips. |
|
1. Luggage side trim [LH]
2. Luggage side trim [RH]
3. TMK tray
4. Luggage cover board
| 5. Rear transverse trim
6. Package tray trim
7. Luggage partition side trim
|
|
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage...
Components and Components Location
Components
1. Windshield glass 2. Windshield moulding mounting bracket3. Windshield glass side moulding4. Windshield glass upper moulding
Repair procedures
Removal
•
Put on gloves to protect your hands...
Other information:
General Information
1.
Check & Change intervals
Check & ReplenishmentChangeCapacityOil specificationNormal UseSevere Use60000 km / 4 years(40000 miles / 4 years) No service required120000 km(80000 miles)1.9 L (0.50 U.S gal., 2.00 U.S qt...
Description
The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. By
converted voltage value, engine ECU controls the cooling fan by
operating it high speed or low speed. Engine ECU stops the operation of
the compressor when the temperature of refrigerant line is very high or
very low irregularly to optimize air conditioning system...
Rear Package Tray Trim Repair procedures
Windshield Glass