| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a screwdriver or remover, remove the fuel filler door open switch (A).
|
| 3. |
Disconnect the fuel filler door open switch connector (A).
|
| 4. |
Apply battery voltage to each terminal No.2 (+) and No.7 (-)
as shown in the table. check for continuity between the terminal No 2
and No 5.
If the operation is abnormal, replace the switch assembly.
|
Removal 1. Disconnect the battery negative terminal. 2. Loosen the alternator tension adjusting bolt (A) to loosen tension. 3. Remove the drive belt (A). Inspection Drive Belt Inspection Visually check the belt for excessive wear, frayed cords etc...
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual Measurement Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front side member tooling hole (O25)Side cover mounting hole (O9)Front sub frame mounting boltCenter floor side member tooling hole (O11)Center floor side member tooling hole (O16)Floor under cover mounting hole (O6...