| Signal Waveform |

| Circuit Diagram |

Electric WGT Control Actuator SpecificationsSpecification [EWGA Position Sensor] Position Output Voltage[V] Operating Angle[°] Range of Rod [mm], reference Mechanical Close end stop Position (MCP) 4...
Electric WGT Control Actuator Repair proceduresInspection [Motor] 1. Turn ignition switch OFF. 2. Disconnect the EWGA connector. 3. Check that the EWGA is stuck by foreign material. 4...
Specification ItemSpecificationRated voltage 13.5V, 130A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Refer to below graph Internal mode 14.55 ± 0.3V Temperature Gradient External mode 0 ± 3 mV / °C? Internal mode -3...
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Disconnect the ASCC ECU connector (A). 3. Remove the ASCC ECU (C) after remove the installation nut (B). Installation 1. Install in the reverse order of removal...